Axxess ASWC Manual do Utilizador descarregar pdf (Página 10)

Troubleshooting the Auto Detect Mode

you tried the auto detect feature and at the end the led

did not stay

solid

red, it started flashing. That means the

ASWC

did not detect the

vehicle. Follow these couple steps to determine what happened:

First some basic steps:

1) Verify that you have 12 volt accessory and a good ground to the

ASWC.

2) Verify with the

vehicle

information sheet on the Axxess website that you

connected the correct steering

wheel

control wires in the

vehicle

to the

correct wire(s) on the

ASWC.

3) Verify that the 3.5mm connector is connected to your radio securely and

the correct location.

using the

female 3.5mm connector on an

Eclipse

Kenwood radio,

verify that the radio's

SWC wire is connected to the correct wire on the

ASWC.

Once all

the information above has been verified and correct, refer back to

the 2 sets

led flashes during the auto detect sequence. Here is what the

flashes stand for:

LED Feedback

The 1st series

led

flashes represent the wire(s) that are connected to the

vehicle from the

ASWC.

Short flashes represent the steering wheel control

wire( s) that are not con-

nected to the

vehicle from the

ASWC.

Long flashes

represent the wire(s) that are connected to the vehicle.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Comentários a estes Manuais

Sem comentários

Axxess ASWC Manual do Utilizador Página 10

Comentários a estes Manuais